TAPPER

BiDir signal tap macro for an ICE-uPAC card

<card>    Name of card alias in hardware config file
<flags>   List of flags to append to the card's config
<config>  Configuration table, if blank uses a global results TAPSET

This macro is a GUI to deploy various resources on an ICE-uPAC card, 
to snapshot or continuously acquire to memory or disk. 
There are also a few protocol analysis tools.

These controls can be initialized using the /GC={MODE=xx,...} syntax.

A Midas log file is created by the name <card>_<port>.mlog.  This file can be filtered
for error messages, up/down times, performance metrics, etc.  It can be retrieved via
NFS, FTP, HTTP, MFTP, etc.

Messages:

Switches:

  /ATL=n    Archive transfer length (in samples) tuned to maximize disk performance
	      (usually 1-2Mby, but less than 1/4 of the RAM buffer length)
  /AAUX=n   Archive auxiliary for single channel archives
  /AAUX1=n  Archive auxiliary for channel 1 in dual channel archives
  /AAUX2=n  Archive auxiliary for channel 2 in dual channel archives

  /GC={}    Table of default parameters for any of the controls.
            This has the form {MODE=RTARCHIVE,HDR=ATTACH,...}