ConvertBot: BiDir signal tap macro for an ICE-uPAC card

2020-04-27T19:19:40Z

BiDir signal tap macro for an ICE-uPAC card

ConvertBot: BiDir signal tap macro for an ICE-uPAC card

2020-04-27T18:59:50Z

BiDir signal tap macro for an ICE-uPAC card

New page

BiDir signal tap macro for an ICE-uPAC card
<pre>
<card> Name of card alias in hardware config file
<flags> List of flags to append to the card's config
<config> Configuration table, if blank uses a global results TAPSET

This macro is a GUI to deploy various resources on an ICE-uPAC card,
to snapshot or continuously acquire to memory or disk.
There are also a few protocol analysis tools.

These controls can be initialized using the /GC={MODE=xx,...} syntax.

A Midas log file is created by the name <card>_<port>.mlog. This file can be filtered
for error messages, up/down times, performance metrics, etc. It can be retrieved via
NFS, FTP, HTTP, MFTP, etc.

Messages:

Switches:

/ATL=n Archive transfer length (in samples) tuned to maximize disk performance
(usually 1-2Mby, but less than 1/4 of the RAM buffer length)
/AAUX=n Archive auxiliary for single channel archives
/AAUX1=n Archive auxiliary for channel 1 in dual channel archives
/AAUX2=n Archive auxiliary for channel 2 in dual channel archives

/GC={} Table of default parameters for any of the controls.
This has the form {MODE=RTARCHIVE,HDR=ATTACH,...}

</pre>

← Older revision		Revision as of 19:19, 27 April 2020
Line 29:		Line 29:

	</pre>		</pre>
		+
		+	[[Category:ICE_Explain]]

TAPPER - Revision history

ConvertBot: BiDir signal tap macro for an ICE-uPAC card

ConvertBot: BiDir signal tap macro for an ICE-uPAC card