SynchronICE-Gen2 - Revision history

Wikiadmin: Redirected page to SynchronICE 200 Series

2020-09-28T21:53:54Z

2020-09-25T17:09:51Z

2020-09-25T15:45:19Z

Specifications

2020-05-19T19:12:28Z

2020-05-19T19:10:34Z

Features

2020-05-19T19:09:57Z

2019-05-27T20:54:57Z

@@ Line 18: / Line 18: @@
 === Front View ===
-{{Figure|Sync_front_panel_1200x266.png|Figure 1 – Front View of the SynchronICE-200 Chassis}}
+{{Figure|Sync_front_panel_1200x266.png|Figure 1 – Front View of the SynchronICE Chassis with Embedded Oscillator}}
 === Rear View ===
-{{Figure|Sync_rear_panel_1200x149.png|Figure 2 ‐ Rear View of the SynchronICE-200 Chassis}}
+{{Figure|Sync_rear_panel_1200x149.png|Figure 2 ‐ Rear View of the SyncronICE Chassis with Embedded Oscillator}}
 {{pagebreak}}

@@ Line 18: / Line 18: @@
 === Front View ===
-{{Figure|Sync_front_panel_1200x266.png|Figure 1 – Front View of the SynchronICE Chassis with Embedded Oscillator}}
+{{Figure|Sync_front_panel_1200x266.png|Figure 1 – Front View of the SynchronICE-200 Chassis}}
 === Rear View ===
-{{Figure|Sync_rear_panel_1200x149.png|Figure 2 ‐ Rear View of the SyncronICE Chassis with Embedded Oscillator}}
+{{Figure|Sync_rear_panel_1200x149.png|Figure 2 ‐ Rear View of the SynchronICE-200 Chassis}}
 {{pagebreak}}

@@ Line 13: / Line 13: @@
 * Optional embedded low phase noise oscillator (See [[#Optional_Embedded_Low_Phase_Noise_Oscillator|Section 3]] for more information)
 * Forward or reserve rack-mountable
 == Specifications ==

← Older revision		Revision as of 20:54, 27 May 2019
Line 7:		Line 7:

	The second generation SynchronICE-Gen2 is functionally similar to the original [[SynchronICE]], with the addition of a redundant 1+1 power supply and extended ordering options.		The second generation SynchronICE-Gen2 is functionally similar to the original [[SynchronICE]], with the addition of a redundant 1+1 power supply and extended ordering options.
		+
		+	More details forthcoming.
	__TOC__		__TOC__

@@ Line 336: / Line 336: @@
 The Huber Suhner 74Z-0-0-79 steel SMA torque wrench is designed for use on SMA connectors. It has a torque of .45 Newton-meters (3.98 inch-pounds) and an opening of 8mm (.315"). Since the proper tightening torque ensures optimal performance over time, this break-over style torque wrench pivots when the torque setting is achieved, preventing over-torque conditions. Ergonomic styling makes the handling of this 4.5" long torque wrench easy.
 {{Status|prod}}
 [[Category:Appliances|05]]