ICE-UDP-10G-r2 - Revision history

Wikiadmin at 19:56, 9 May 2020

2020-05-09T19:56:07Z

Wikiadmin at 20:36, 6 June 2018

2018-06-06T20:36:31Z

Wikiadmin at 20:36, 6 June 2018

2018-06-06T20:36:13Z

Wikiadmin at 20:34, 6 June 2018

2018-06-06T20:34:58Z

Wikiadmin: Created page with "
10Gbit UDP Module
{{eolnotice|ICE-UDP-10G-R3}} thumb == Features == * Hooks directly to 10GbE fiber..."

2018-05-22T15:29:02Z

Created page with "<div class="description">10Gbit UDP Module</div> {{eolnotice|ICE-UDP-10G-R3}} thumb == Features == * Hooks directly to 10GbE fiber..."

New page

<div class="description">10Gbit UDP Module</div>
{{eolnotice|ICE-UDP-10G-R3}}
[[FIle:Ice-udp-10g-r2-connector-side.jpg|thumb]]
== Features ==

* Hooks directly to 10GbE fiber optic network, for data acquisition/playback from/to a network at full 10GbE line rates
* Supports bidirectional network communications in one module
* Supports ARP/RARP protocols for remote IP address receipt or user-definable IP addresses
* Encapsulates UDP & IP protocols in hardware
* Ability to turn on or off VLAN tags
* Software: X-Midas/NeXtMidas and C user interfaces

'''Note:''' For use with the [[ICE-PIC6|ICE-PIC6 card]]

== Data Acquisition (Input) Modes ==

* IGMP support for dynamic multicast join/leaves/membership reports
* Currently supports up to 4 or 8 (depending on acquire mode), IGMP groups may be joined during a single acquisition
* "Raw" bit acquire mode: acquires ALL bits on the 10GbE fiber
* Raw packet acquire mode: acquires ALL packets regardless of type, removes inter-packet gap
* SDDS packet only mode (ethernet header, IP header, UDP header, SDDS header, and SDDS Data) acquire mode
* SDDS data & SDDS header acquire mode: all other packet headers discarded
* SDDS data acquire mode with all other packet headers discarded
* Hardware endian swapping options for incoming acquisitions
* Hardware support to check for dropped packets during a acquisition (missing sequence counters)
* Hardware support for "auto-fill" for missed packets so that sample timing may be maintained
* Support samples sizes: packed 4-bit data (2 4-bit samples per 8-bit slot), 6-bit data (zero-padded to 8), 8-bit, & 10-, 12-, 14-, 16-bit (zero-padded to 16)
{{pagebreak}}
* Ability to pull out time stamps from headers and provide offset/pointer to sample that is tied to that value
* Ability to filter SDDS parity packets and non-standard SDDS packets
* Onboard 512 MByte memory buffer for EACH channel to support "bursting" network routers (FPGA firmware under development: available 10/12)
* Support for input "ping-pong" mode from 2 fiber sources and reassembly into one data stream (FPGA firmware under development: available 10/12)

== Data Playback (Output) Modes ==

* Raw data Tx mode: user supplies SDDS data only, TGSDDSxD module will insert network/SDDS headers for transmit on 10GbE fiber
* Raw data Tx Mode: automatic insertion of packet-count sequence in SDDS header
* Raw SDDS data Tx mode: user supplies SDDS data & SDDS header Only, TGSDDSxD module will insert network headers for transmit on 10GbE fiber
* User-selectable/programmable Tx packet sample rates available up to full 10GbE rates (SDDS data rate of 1100 MB/Sec) via onboard 10MHz reference or user-supplied 10Mhz reference
* Raw data or daw SDDS "ping-pong" output mode: allows for Tx operations of a single stream to both transceivers at up to 1400MB/Sec (data rate split across two fibers at 700MB/Sec)
* Use of external 10MHz reference allows user to lock to a dedicated site reference for coherent playback of multiple modules; if no site reference is available, then onboard reference can be used to generate Tx sample clock

== Documentation ==

<div class="plain-img">
[[File:pdf_icon_22x22.png]] Documentation for Flags and Examples of the Modules: [[Media:Tgsxdr2_flagsexplain_examples.pdf|TGSXDr2_flagsexplain_examples.pdf]]
</div>

== Status and Configurations ==
{{Status|eol}}

The standard configuration employs the 1310nm Fiber Interface.<br />
If desired, 850nm fiber interface is available through special order. ([[Contact|Call for pricing]]).

[[Category:Communication_modules]]
[[Category:EOL]]
{{footer}}

@@ Line 44: / Line 44: @@
 <div class="plain-img">
-[[File:pdf_icon_22x22.png]] Documentation for Flags and Examples of the Modules: [https://downloads.ice-online.biz/datasheets/tgsxdr2_flagsexplain_examples.pdf TGSXDr2_flagsexplain_examples.pdf]
+[[File:pdf_icon_22x22.png]] Documentation for Flags and Examples of the Modules: [https://downloads.ice-online.com/datasheets/tgsxdr2_flagsexplain_examples.pdf TGSXDr2_flagsexplain_examples.pdf]
 </div>

@@ Line 44: / Line 44: @@
 <div class="plain-img">
-[[File:pdf_icon_22x22.png]] Documentation for Flags and Examples of the Modules: [[https://downloads.ice-online.biz/datasheets/tgsxdr2_flagsexplain_examples.pdf TGSXDr2_flagsexplain_examples.pdf]]
+[[File:pdf_icon_22x22.png]] Documentation for Flags and Examples of the Modules: [https://downloads.ice-online.biz/datasheets/tgsxdr2_flagsexplain_examples.pdf TGSXDr2_flagsexplain_examples.pdf]
 </div>

@@ Line 44: / Line 44: @@
 <div class="plain-img">
-[[File:pdf_icon_22x22.png]] Documentation for Flags and Examples of the Modules: [[https://downloads.ice-online.biz/datasheets/TGSXDr2_flagsexplain_examples.pdf]]
+[[File:pdf_icon_22x22.png]] Documentation for Flags and Examples of the Modules: [[https://downloads.ice-online.biz/datasheets/tgsxdr2_flagsexplain_examples.pdf TGSXDr2_flagsexplain_examples.pdf]]
 </div>

ICE-UDP-10G-r2 - Revision history

Wikiadmin at 19:56, 9 May 2020

Wikiadmin at 20:36, 6 June 2018

Wikiadmin at 20:36, 6 June 2018

Wikiadmin at 20:34, 6 June 2018

Wikiadmin: Created page with "10Gbit UDP Module {{eolnotice|ICE-UDP-10G-R3}} thumb == Features == * Hooks directly to 10GbE fiber..."

Wikiadmin: Created page with "
10Gbit UDP Module
{{eolnotice|ICE-UDP-10G-R3}} thumb == Features == * Hooks directly to 10GbE fiber..."